Setting Up the icRoute Application

The icRoute tab is displayed only if the icRoute application has been assigned to this tenant. This section assumes both that the icRoute application has been assigned to this tenant and that the icRoute tab (see the following screen capture) is currently the active tab in the Tenant Creation page.

You can use the icRoute tab to configure the icRoute application for the new tenant. If the icRoute tab is not the active tab, click on the tab to make it the active tab.

If the icRoute application has been assigned to the tenant that you are currently setting up, you can use the icRoute tab to configure the icRoute application for the new tenant.

Enter the following information to set up icRoute for the new tenant:

  • Port Number - Required. The port number used by the Application Gateway (AG). Enter the number of the port that you want to assign to the AG.

  • Time Zone - The time zone in which the Application Gateway (AG) Central Controller is located. Click anywhere in the box to open the drop-down menu and click on the time zone in which the AG (Application Gateway) Central Controller is located.

  • Heartbeat Timeout - Required. The amount of time in seconds (the response time) to wait before a ping to the Application Gateway (AG) is considered to be timed out. You can change the timeout by over-typing the existing value with a new value.

  • Daily Reload of Caching - Use the decision icon to enable or disable the daily cache reload. If the decision icon is set to "NO", you can click on the decision icon to change the value to "YES" to enable the daily cache reload. If the decision icon is set to "YES", you can click on the decision icon to change the value to "NO" to disable the daily cache reload.

  • Daily Reload Caching Time - If the Daily Reload of Caching decision icon is set to "YES", you can set a time at which daily caching can take place. To enter the time at which you want to reload the cache each day, change the time by performing one of the following actions:

    • Click on the up or down arrows to change the displayed hours and minutes in their respective boxes to change the time at which to reload the cache.

    • Click in either the hours box or the minutes box. You can over-type the value in one or both boxes to change the time at which to reload the cache.

After providing all required information in the icRoute tab, click on the Save button to save your settings.